Stamping Tool for leather carving manufactured by OKA FACTORY.
Stamp Type: Original
Made in Japan
① I made the pattern symmetrical.
I deepened the engraving of the pattern so that it would not touch the bottom of the leather.
Therefore, three-dimensional stamping is possible.
The thickness of the patterned surface was increased by about 4.5 mm to reinforce it so that it would not deform even if it was hit hard on thick leather.
② Engraving tool number and MADE IN JAPAN.
③ Tools are plated whole over.
④ Knurling the body makes it allows getting a better grip.
7.5 mm × 8.5 mm
HOW TO USE
Leather must be moistened by rubbing a damp sponge on it.
Place leather on top of a firm surface like marble or rubber board.
Use a wood or raw hide mallet head to strike the top of the stamp to obtain its impression in the leather.
Control over degree and force of striking depend on the case.